Installation Sheet

ManualsBrandsTech Lighting ManualsChandeliersTech Lighting Gambit 19 Light 2700K LED Multi-Port Chandelier

Preparing the Canopy

Mount the crossbar assembly to the electrical box with

the two provided #8-32 screws.

Remove the crossbar from the canopy by completely

unscrewing the center strain relief.

SET SCREW

Loosen the set screw on each strain(Do Not Remove)

relief.

920GMBMP19

1.0

700GMBMP19_

#8-32

SCREW

CROSSBAR

CENTER STRAIN

RELIEF

CROSSBAR

CANOPY

Line an anchor tip with the center of an anchor holes,

and push the anchors into the wall up to the threads.

Screw the anchors in the rest of the way with a Phillips-

head screwdriver.

Slide each #8 screw through a washer, and screw them

into the anchors to secure the mounting plate.

GP I :ENERAL RODUCT NFORMATION

This product is suitable for damp locations.

These fixtures are intended to be installed

utilizing NEC compliant junction boxes.

This product can be dimmed with a LED or TRIAC dimmer.

Consult lamp manufacturer for additional information.

This instruction shows a typical installation.

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Gambit 19-Light Chandelier

Installation Instructions for

CHANDELIER

Summary of content (4 pages)

PAGE 1
920GMBMP19 Installation Instructions for Gambit 19-Light Chandelier 700GMBMP19_ 1.0 CHANDELIER GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product can be dimmed with a LED or TRIAC dimmer. Consult lamp manufacturer for additional information.
PAGE 2
Install the Fixture 2A 2D CORD HUB ALLEN KEY 7 SET SCREW 6 CORD CORD Feed a fixture cord through each hole in the cord hub. 1 CORD HUB CORD 6 Position the cord hub to desired location. 7 Secure the cord hub in place by using the provided Allen key to carefully tighten the set screws against the cords until snug. Do not over tighten . 2B 1A 2E STRAIN RELIEF CANOPY CORD STRAIN RELIEF 4" CORD Feed a fixture cord through each strain relief.
PAGE 3
2F 2G 15 13 15 14 GROUND WIRE 16 WAGO CONNECTORS CENTER FIXTURE CORD WIRE STRIPS 12 Follow the above wire diagram and connect neutral fixture wires (white tracer) using the provided Wago connectors and wire strips. Leave the center fixture wires unconnected for now. Lift up the tabs on the Wago connectors and insert wires all the way in, then press the tabs closed until they snap into place. 13 Connect neutral power line to one of white wire strips provided to the chain of Wago connectors.
PAGE 4
Install the Canopy 3A 1A 4A 3A 1A 3A BASE 4 SET SCREW STRAIN RELIEF GLASS CORD NOTE: It is recommended that one person hold the CAUTION: DO NOT OVER TIGHTEN the glass. This fixture while the electrician finishes the installation. 1 may break the glass resulting in injury. Place all wires, wire nuts and Wago connector connections properly inside the canopy. 2 While supporting the fixture, loosen the set screw on the center strain relief.