Installation Sheet

ManualsBrandsTech Lighting ManualsPendantsTech Lighting Gambit LED 7 Light Pendant with Glass Globe Shades

Installation Instructions for

Gambit 7-Light Chandelier

Preparing the Canopy

#8-32

SCREW

CROSSBAR

Mount the crossbar assembly to the electrical box with

the two provided #8-32 screws.

Remove the crossbar from the canopy by completely

unscrewing the center strain relief.

CENTER STRAIN

RELIEF

CROSSBAR

CANOPY

SET SCREW

Loosen the set screw on each strain(Do Not Remove)

relief.

920GMBMP7

Install the Fixture

CANOPY

Feed a fixture cord through each the strain relief.

Note: Taping down the frayed end of the cloth may

assist in feeding it through the strain relief.

2 2

1.0

700GMBMP7_

CHANDELIER

CORD

STRAIN RELIEF

CORD

GP I :ENERAL RODUCT NFORMATION

This product is suitable for damp locations.

These fixtures are intended to be installed

utilizing NEC compliant junction boxes.

This product can be dimmed with a LED or TRIAC dimmer.

Consult lamp manufacturer for additional information.

This instruction shows a typical installation.

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Summary of content (4 pages)

PAGE 1
920GMBMP7 Installation Instructions for Gambit 7-Light Chandelier 700GMBMP7_ 1.0 CHANDELIER GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product can be dimmed with a LED or TRIAC dimmer. Consult lamp manufacturer for additional information.
PAGE 2
B 2D 2 3 12 STRAIN RELIEF 10 SET SCREW CORD 2 Adjust each fixtures’ height (from bottom of the fixture shade to top of the canopy) by pulling the fixture cords through the strain relief. 3 When the desired look is achieved, tighten the set screw on each strain relief. 8 9 2C 8 Leave the center cord for now and connect half of the fixture wires with the white tracer as well as one of the provided white wire strips together with one of the provided wire nuts.
PAGE 3
Install the Canopy Install the Lamp and Shade 3A 3A 1A 4A SOCKET LAMP SET SCREW STRAIN RELIEF CORD C AUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. NOTE: It is recommended that one person hold the fixture while the electrician finishes the installation. Refer to fixture marking for lamp information Screw the lamp into the socket. 1 1 Place all wires and wire nut connections properly inside the canopy.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2017 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.