Installation Sheet

ManualsBrandsTech Lighting ManualsChandeliersGrace Single Light 30" Wide LED Ring Chandelier

Installation Instructions for

Grace 30, 36, and 48 Chandelier

Prepare the Canopy

#8-32

SCREW

MOUNTING

PLATE

Install the mounting plate to the electrical box with the

two provided #8-32 screws.

Remove all the canopy screws from the canopy using the

provided Allen Wrench and remove the mounting plate.

920GRACE

MOUNTING

PLATE

Using the provided Allen wrench, loosen (Do Not

Remove) the set screw on each strain relief.

Place the fixture on a level surface.

Evenly pull the three coaxial cables through the canopy

until it reaches the length desired.

Ensure that the canopy is level and re-tighten the set

screws on the strain reliefs.

CAUTION RISK OF FIRE-

This product must be installed in accordance with the

applicable installation code by a person familiar with

the construction and operation of the product and the

hazards involved.

Use minimum 90°C supply conductors.

SUSPENSION

SAVE THESE INSTRUCTIONS!

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing NEC compliant junction boxes.

This product is suitable for damp locations.

This product can be dimmed with a low-voltage

electronic dimmer. 277 versions: 0-10V dimmer.

1.0

1.7

700GRC24, 700GRC30, 700GRC36, 700GRC48

CANOPY SCREW

ALLEN WRENCH

CANOPY

CABLE

SET SCREW

ALLEN WRENCH

CABLE

STRAIN

RELIEF

Summary of content (4 pages)

PAGE 1
Installation Instructions for 920GRACE Grace 30, 36, and 48 Chandelier 700GRC24, 700GRC30, 700GRC36, 700GRC48 SUSPENSION GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. This product can be dimmed with a low-voltage electronic dimmer. 277 versions: 0-10V dimmer.
PAGE 2
Shorten Cords for 30 (Optional) Shorten Cords for 36 & 48 (Optional) 2A 4A DUMMY COAXIAL CORD
PAGE 3
Additional Leveling (optional) 5B NOTE: If necessary, minor leveling adjustments to the fixture may be needed. It is recommended that one person hold the fixture straight with the use of a level while the other adjusts the coaxial cable. CAUTION: Only pull out extra cable for leveling if 6 enough cord was left behind the canopy. Minimal amounts of cord should be pulled out for fine leveling.
PAGE 4
7400 Linder Ave., Skokie, IL 60077 T 847.410.4400 | F 847.410.4500 www.techlighting.com ©2021 Tech Lighting, L.L.C. All rights reserved. The Tech Lighting logo is a registered trademark of Tech Lighting. Tech Lighting reserves the right to change specifications for product improvements without notification.