Installation Sheet
2
2
3
4
5
Wire the Fixture (for 36 & 48)
2A
1
2
3
Shorten Cords for 30 (Optional)
NOTE: If shortening is necessary, ensure that the cable
identifiers are not removed during installation. If no
shortening is necessary, skip to section 3A.
Leave 6" behind for wire connections, cut off the excess
cord. NOTE: This fixture contains two dummy coaxial
cords.
From the end of the cord, strip the jacket and braided
shield 4" using a sharp knife. Make sure not to nick the
center conductor wire.
Strip the end of the center conductor wire.
DUMMY COAXIAL CORD
4A
1
2
3
Leave 6" behind for wire connections, cut off the excess
cord. NOTE: This fixture contains one dummy coaxial
cord.
From the end of the cord, strip the jacket 4" using a
sharp knife. Make sure not to nick the braided shield
and center conductor wire.
Without nicking the center wire conductor, make a
1/4” cut at the base of the exposed braided shield and
pull the center conductor wire out. Make sure not to
further damage the braided conductor while doing
so.
Strip the end of the center conductor wire.
DUMMY COAXIAL CORD
BRAIDED
CONDUCTOR
CENTER
CONDUCTOR WIRE
COAXIAL CORD
COAXIAL CORD
1
4
1
DRIVER DRIVER
4
4
3
2
+
-
-
+
5A
Connect the fixture ground wire to a suitable ground in
accordance with local electrical codes.
Connect the braided conductor wire from one of the
fixture cords to a black driver wire labeled “-” (negative)
with a wire nut. NOTE: Ensure that the braided shield
is being connected, not the center conductor wire.
Connect the center conductor wire from one of the
fixture cords to a red driver wire labeled “+” (positive)
with a wire nut. NOTE: Ensure that the center
conductor wire is being connected, not the braided
coaxial shield.
Repeat step 1-3 for the other fixture cord.
1
2
3
Wire the Fixture (for 30)
Shorten Cords for 36 & 48 (Optional)
NOTE: If no shortening is necessary, skip to section 5A.
4
INSULATION
BRAIDED
SHIELD
CONDUCTOR
JACKET
CENTER WIRE
INSULATION
BRAIDED
SHIELD
CONDUCTOR
JACKET
CENTER WIRE
CENTER
CONDUCTOR WIRE
BRAIDED
CONDUCTOR
-
3
1
4
5
+
2
DRIVER
3A
-
Connect the fixture ground wire to a suitable ground in
accordance with local electrical codes.
Connect the braided conductor wire to the black driver
wire labeled “-” (negative) with a wire nut. NOTE:
Ensure that the braided shield is being connected,
not the center conductor wire.
Connect the center conductor wire to the red driver wire
labeled “+” (positive) with a wire nut. NOTE: Ensure
that the center conductor wire is being connected,
not the braided coaxial shield.
Connect the black 120V input to the hot power line wire
with a wire nut.
Connect the white 120V input to the neutral power line.