Installation Guide

2
SAVE THESE INSTRUCTIONS!
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to person:
– Use this fixture indoors only.
– Do not look directly at the lighted lamp.
– Do not remain in light if skin feels warm.
– Risk of fire: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
– Never cover the halogen lamp with anything other than a
Tech Lighting lamp shield and never place flammable
material close to your fixture.
– Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
– Do not touch the fixture shades or lamp while the fixture
is on. These surfaces may be HOT.
– The MR16 lamp must have a protective front cover glass.
Halogen Lamp General Information
– A new halogen lamp may smoke slightly when it is used
for the first time. This is perfectly normal; the protective
coating is simply being vaporized.
Two Tips For Prolonging Halogen
Lamp Life
– First avoid touching the lamp with bare hands during
installation. Any contaminant, even the oil from your
hands can deteriorate the lamp. Rubbing alcohol can be
used to remove any contaminant.
– Second, do not run the lamps at full power when you do
not need to. However, if dimming the fixture for an
extended period of time, occasionally bring the light up to
full brightness for a few minutes to complete the halogen
cycle.
Turn the power to the electrical box off.
In accordance with local electrical codes, ground the
transformer green wire.
Connect the 120 volt white transformer wire to the
neutral power line wire with a wire nut.
Connect the 120 volt black transformer wire to the hot
power line wire with a wire nut.
Place the transformer and all the wires inside the
electrical box. Use the adhesive pad to secure the
transformer in the electrical box.
Mount the 4" round canopy to the electrical box with the
two long #8-32 screws.
120 VOLT
POWER WIRES
12 VOLT
TRANSFORMER
WIRES
LONG #8-32
ROUND HEAD
SCREW
4" ROUND
CANOPY
CEILING
ELECTRICAL BOX
NOTE: Use the provided universal round crossbar
when the canopy holes do not line up with the
electrical box holes.
Installing the Fixture
2A
1
2
3
4
5
6
2
3
4
5
6
7400 Linder Ave, Skokie, IL 60077
847.410.4400
www.techlighting.com
© 2008 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company