Installation Sheet

1A
Install the Fixture
1
Remove all the canopy screws using the provided Allen Wrench.
Remove the mounting plate from the canopy and remove the driver from the packaging.
Secure the mounting plate to the electrical box with the #8-32 screws provided.
Determine the desired height of the fixture using the provided stems and assemble them by screwing them together
ensuring that the stem with attached nut is on the top.
Feed the fixture wires through the stem assembly, then screw the stem assembly to the top of the fixture.
Feed the fixture wires through the canopy, washers and hex nut, then screw the hex nut onto the stem assembly to
secure together.
Connect the black/blue driver wire to the black/blue fixture wire with a wire nut.
Connect the red driver wire to the red fixture wire with a wire nut.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white driver wire to the neutral power line with a wire nut.
Connect the black driver wire to the hot power line with a wire nut.
For 277V Only: If using 0-10V dimming, connect the purple and gray wires to a compatible dimmer. If not using 0-10V
dimming, cap off the purple and gray wires.
Neatly place the drivers, all wires, and wire nut connections inside the canopy, align the canopy holes with the mounting
plate holes, and secure the canopy in place by tightening the Allen screws using the provided Allen Wrench.
Rotate the fixture arms so they are in the desired position and tighten the screws to hold them in place.
2
3
4
5
6
7
8
9
10
11
12
13
2
CANOPY
STEM ASSEMBLY
FIXTURE
4
5
4
ATTACHED NUT
LARGE
WASHER
HEX NUT
SMALL
WASHER
DRIVER
DRIVER
CANOPY
MOUNTING
PLATE
#8-32 SCREW
ALLEN
WRENCH
& SCREW
7
8
9
10
11
12
6
15
FIXTURE ARM
15
14