Installation Sheet

Install the Fixture

CANOPY

SCREW

CANOPY

#8-32 SCREW

MOUNTING PLATE

SET SCREW

ALLEN WRENCH

CORD

CANOPY

SCREW

CORDCORD

CANOPY

Remove the canopy screws located on the sides of the canopy, then remove the mounting plate from the canopy.

Install the mounting plate onto the electrical box with the two #8-32 screws provided.

Adjust the Height (Optional): Determine the desired height of the fixture by loosening the set screws on the strain

reliefs using the provided Allen Wrench and evenly feeding the cords into the canopy. Re-tighten the sets screws

once the desired height is achieved.

Connect the fixture to suitable ground in accordance with local electrical codes.

Connect the white fixture wire to the neutral power line wire with a wire nut.

Connect the black fixture wire to the hot power line wire with a wire nut.

For 277V Only: If using 0-10V dimming, connect the purple and gray wires to a compatible dimmer. If not using 0-

10V dimming, cap off the purple and gray wires.

Properly place all wires and wire nut connections into the canopy, mount the fixture back onto the mounting plate,

and reinstall fixture screws (reversal of step 1).

NOTE: If minor adjustments to the fixture's leveling is necessary, it is recommended that one person hold the fixture

straight with the use of a level while the other adjusts the cords following the steps below.

Fine Leveling (Optional): (do not remove)Loosen the set screws on the necessary strain relief and gently pull or

push the cord in very small increments through the strain relief to adjust the height of the fixture. Re-tighten the set

screw on the strain relief using the provided Allen Wrench.