Installation Sheet

ManualsBrandsTech Lighting ManualsChandeliersTech Lighting Crossroads Linear Suspension LED Linear Chandelier - 277v

Install the Mounting Plate

Separate the mounting plate from the canopy by

removing all four screws.

Secure the mounting plate to the electrical box with the

two #8-32 screws provided.

SCREWSCREW

CANOPY

Remove the mounting plate from the canopy.

MOUNTING PLATE

1.1

Installation Instructions for

Crossroads Linear Suspension (LED)

700LSCRS_-LED

920LSCRSSD

CEILING

MOUNTING

PLATE

#8-32 SCREW

GP I :ENERAL RODUCT NFORMATION

This fixture is intended to be installed utilizing

NEC compliant junction boxes.

This product is suitable for dry locations only.

CAUTION RISK OF FIRE-

This product must be installed in accordance with the

applicable installation code by a person familiar with the

construction and operation of the product and the

hazards involved.

Use minimum 90°c supply conductors.

Summary of content (4 pages)

PAGE 1
920LSCRSSD Installation Instructions for Crossroads Linear Suspension (LED) 700LSCRS_-LED 1.1 CEILING GENERAL PRODUCT INFORMATION: This fixture is intended to be installed utilizing NEC compliant junction boxes. This product is suitable for dry locations only. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Use minimum 90°c supply conductors.
PAGE 2
Assemble the Fixture 1D 2A 3 1 CABLE CLUTCH POWER CORD 4 AIRCRAFT CABLE 4 Line up an anchor with the center of a backplate hole and push the anchor in up to the threads. 5 Screw the anchor the rest of the way in with a screwdriver. 1E 7 NOTE: Make sure to support the fixture while adjusting the aircraft cables. An assistant is recommended to complete the remaining steps. 6 6 Secure the backplate to the anchor with a screw and washer. 7 Repeat steps 4-6 for the remaining anchor hole.
PAGE 3
Adjust the Height 3A Install the Fixture to the Canopy DRIVER WIRE 4A POWER CORD WIRE 6 7 1 8 Take note of the wire connections and remove the wire nuts to disconnect the power cord wires from the driver wires. 3B 3 CORD GRIP CAP 2 CORD 3 NOTE: The power cord does not support the fixture. For a casual “lazy cord” look, cut the power cord several inches longer that the drop height of the fixture. 2 From front of the canopy remove the cap from the cord grip.
PAGE 4
B B SCREW SCREW SAVE THESE INSTRUCTIONS! 9 Place all wires and wire nut connections inside the canopy. 10 Align the canopy holes with the crossbar holes. Secure the canopy in place by tightening the four screws. 4C 11 CABLE CLUTCH BAND CABLE CLUTCH BAND 11 Adjust the aircraft cables until the fixture is level; feed the cable into the cable clutch to raise the fixture and push in on the cable clutch nipple to release the cable and lower the fixture. 7400 Linder Ave, Skokie, IL 60077 847.410.