Manualshelf

Installation Sheet

ManualsBrandsTech Lighting ManualsChandeliersDessau 49" Wide LED Linear Chandelier with Aluminum Shade
12
2
Remove the Allen screws on the sides of the canopy using the provided Allen wrench, then remove the mounting plate
from the canopy.
Install the mounting plate to the junction box with the two #8-32 screws provided.
Verify that the mounting plate is level before continuing. Line up an anchor tip with the center of an anchor hole, and push
the anchor into the wall up to the threads.
Screw the anchor in the rest of the way with a Phillips-head screwdriver.
Slide an anchor screw through a washer, and screw it into an anchor to secure the fixture base to the wall. Repeat steps 3-5
for remaining anchors.
To adjust the Fixture Height place the fixture on a level surface. With the provided Allen wrench, loosen (do not remove) the
set screws on the strain reliefs. Then evenly pull the cables up through the strain reliefs to raise the fixture to the desired
height. Ensure that the canopy is level and re-tighten the set screws on the strain reliefs.
(For Optional CCT:) The fixture will come with the 3000K option pre-configured. To change to 2700K, disconnect the wire
marked 3000k from the wire nut or Wego connected to the red wire. Then connect the wire marked 2700K to the red wire
with the wire nut or Wego. Do not connect both 2700K and 3000K wires simultaneously, as it may result inWARNING:
damaging the fixture.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white driver wire to the neutral power line with a wire nut.
Connect the black driver wire to the hot power line with a wire nut.
For 277V Only: If using 0-10V dimming, connect the purple and gray wires to a compatible dimmer. If not using 0-10V dimming,
cap off the purple and gray wires.
Properly place the driver, all wires, and wire nut connections into the canopy/junction box, mount the fixture back onto the
mounting plate, and reinstall Allen screws (reversal of step 1).
Fine Leveling (Optional): Loosen (do not remove) the set screws on the necessary strain relief and gently pull or push the
cable in very small increments through the strain relief to adjust the height of the fixture. Re-tighten the set screw on the
strain relief using the provided Allen Wrench.
1
1A
2
3
4
5
6
7
8
9
10
11
12
ALLEN WRENCH
& SET SCREW
STRAIN
RELIEF
13
ALLEN WRENCH
& ALLEN SCREW
9
10
11
ANCHOR SCREW
& WASHER
ANCHOR
#8-32 SCREW
DRIVER
6
2
7
1
12
30
00K
2
7
0
0
K
3000K
2700K
3000K
2700K
7
7
3000K
WIRE CONFIGURATION
2700K
WIRE CONFIGURATION