Installation Sheet

Secure the mounting plate to the junction box with #8-

32 screws.

If using one cable post insert the aircraft cable into the

canopy port and secure with the provided set screw.

Feed the coaxial cable though the hole on the side of the

port into the canopy.

If using two cable post feed the coax through the center

port and secure with the provided set screw at the

desired length.

Install Surface Mount Canopy

Slide the coax jumper over the coax and fasten it in place

with provided set screw.

Cut the coaxial cable to the desired length. (Leave longer

than the aircraft cables for a lazy cable look.)

Slide back the braiding to expose the inner wire and

strip some of the inner jacket.

Connect the black driver wire to the black wire coming

from the coaxial jumper.

Connect the red driver wire to the exposed inner wire

Wrap the coaxial cable and coax jumper with electrical

tape, ensuring no part can make contact with the

canopy.

Connect the mounting plate to a suitable ground in

accordance with local electrical codes.

Connect the white wire to the neutral power line wire

with a wire nut.

Connect the black wire to the hot power line wire with a

wire nut.

Neatly place all wires and wire nut connections into the

canopy.

Place the canopy onto the mounting plate and secure

with the canopy screws. (Reversal of step 1A.)

MOUNTING PLATE

#8-32 SCREW#8-32 SCREW

COAX CABLE

AIRCRAFT

CABLE

COAX JUMPER