Installation Sheet

Install Remote Driver and Canopy
3A
PHILLIPS SCREW
1
DRIVER
COVER
3B
CONDUIT
Remove the four Phillips screws to remove the driver
cover.
Secure the driver housing in place (hardware not
included).
Install a conduit and power line wires from the panel to
the remote driver.
Do not connect the power line wires to the panel at this
time.
Make sure the driver housing is grounded in accordance
with local electrical codes.
Connect the driver white wire to the neutral power line
wire with a wire nut.
Connect the driver black wire to the hot power line wire
with a wire nut.
1
2
3
4
5
6
7
1 1
1
1
1
7
1
3
4
6
4
NOTE: For the 4’ fixture the MAX wire length is 100ft
from the driver to the junction box with 18AWG.
for the 8’ fixture the MAX wire length is 50ft from
the driver to the junction box with 18AWG.
NOTE: Other wire sizes that comply with electrical
code can be used, but may result in an increased
voltage drop and reduced lamp intensity.