Installation Sheet

CONDUIT

LOW VOLTAGE

WIRES

Install a conduit from the driver to the electrical box.

Install the low voltage wires from the driver to the

electrical power feed box.

Connect the blue and red driver wires to each low

voltage wire with a wire nut.

DRIVER

COVER

PHILLIPS SCREW

Connect the 120 volt power line wires at the panel.

After installing the entire system, operate the system for

five minutes. On the low voltage side, all electrical

connection points should be no more than warm to the

touch. If a connection is hot to the touch, retighten the

connection and check to ensure that the temperature

decreases.

Replace the driver cover and tighten the four Phillips

screws.

13 13