Installation Sheet

ManualsBrandsTech Lighting ManualsChandeliersEssence 3 Light 50" Wide 3000K LED Linear Chandelier with Acrylic Diffuser

Installation Instructions for

Essence Trio Suspension

1.0

700LSESN3_

920LSESSENT

Install the Canopy

GP I :ENERAL RODUCT NFORMATION

This product is suitable for indoor dry locations only.

This product can be dimmed with a low-voltage electronic dimmer.

Remove the three #8-32 screws on the canopy housing.

Lift the mounting plate from the housing.

#8-32 SCREW

CANOPY HOUSING

MOUNTING PLATE

Align the mounting plate slots with the electrical box holes and

mark four points onto the ceiling through the mounting holes.

With a hammer tap the anchors at the marked points into the

ceiling up to the threaded portion.

Screw the anchors in the rest of the way with a Phillips

screwdriver.

ANCHOR

MOUNTING PLATE

Feed the power line wires through the mounting plate

center hole.

Line up the two mounting plate slots with the electrical box

holes and use the two provided #8-32 screws to mount it to

the electrical box.

#8-32 SCREW

1A 1C

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

SUSPENSION

Summary of content (4 pages)

PAGE 1
Installation Instructions for 920LSESSENT Essence Trio Suspension 700LSESN3_ 1.0 SUSPENSION GENERAL PRODUCT INFORMATION: This product is suitable for indoor dry locations only. This product can be dimmed with a low-voltage electronic dimmer. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Install the Canopy Use minimum 90°c supply conductors.
PAGE 2
1G 1E 8 #8 SCREW 8 11 10 12 8 8 15 Secure the mounting plate to the four anchors with the four provided #8 screws. 10 Connect the black fixture wire to the hot power line wire with a wire nut. 11 Connect the white fixture wire to the neutral power line wire with a wire nut. 12 Connect the canopy to a suitable ground in accordance with local electrical codes.
PAGE 3
2B 2F INNER WIRE STOPS HERE ALLEN WRENCH 8 SET SCREW 2 3 8 2 Back out (do not remove) the set screw on the cylindrical connector with the provided Allen wrench. Keep pushing the coaxial cable into the connector while rotating the connector to ease feeding the inner wire into the tip of the connector. 15 3 Pull the coaxial cable out. 2G 2C OUTER JACKET + 5 BRAIDED CABLE INNER WIRE SIGHT HOLE 1-1/2” 9 9 INNER WIRE NOTE: Be careful to not cut the insulation from the inner wire.
PAGE 4
Install the fixture 3A - + 1 1 + - 14 1 Screw each connector completely into canopy ports. Making sure to match the positive connector with the positive canopy port and the negative connector with the Negative canopy port directly opposite of each other. 15 2 Turn the power on. SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2018 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C.