Installation Sheet

Secure the mounting plate to the four anchors with the four
provided #8 screws.
#8 SCREW
Place all wires and wire nut connections properly inside
the housing.
Slide the housing onto the mounting plate and line up the
housing holes with the mounting plate holes.
Replace and tighten the three #8-32 screws to secure the
housing in place.
1E
1H
1F
15
8
14
13
15
14
8
8
8
12
15
15
Hook a safety cable through the safety brackets on each
end of the canopy and backplate.
1
SAFETY
BRACKETS
9
9
SAFETY
CABLE
15
2
1G
Connect the black fixture wire to the hot power line
wire with a wire nut.
Connect the white fixture wire to the neutral power line
wire with a wire nut.
Connect the canopy to a suitable ground in accordance
with local electrical codes.
10
11
12
11
10
Adjust The Cable Length (Optional)
2A
SET SCREW
ALLEN WRENCH
1
Back out (do not remove) the set screw on tip of the
connector with the provided Allen wrench.
151