Installation Guide

ManualsBrandsTech Lighting ManualsPendantsTech Lighting Knox Linear Suspension LED Pendant

Install the Mounting Plate

Separate the mounting plate from the canopy by

removing all four screws.

Secure the mounting plate to the electrical box with the

two #8-32 screws provided.

SCREWSCREW

CANOPY

Remove the mounting plate from the canopy.

MOUNTING PLATE

1.0

Installation Instructions for

CEILING

GP I :ENERAL RODUCT NFORMATION

This product is suitable for damp locations.

This product can mount to either a 4" square electrical box

with round plaster ring or an octagon electrical box.

CAUTION—RISK OF FIRE

This product requires installation by a qualified

electrician. Before installing be sure to read all

instructions and TURN OFF POWER TO THE

ELECTRICAL BOX.

MOUNTING

PLATE

#8-32 SCREW

Knox Linear Suspension (LED)

700LSKNOX_-LED

920LSKNXD

Summary of content (4 pages)

PAGE 1
920LSKNXD Installation Instructions for Knox Linear Suspension (LED) 700LSKNOX_-LED 1.0 CEILING GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. This product can mount to either a 4" square electrical box with round plaster ring or an octagon electrical box. C AUTION — RISK OF FIRE This product requires installation by a qualified electrician. Before installing be sure to read all instructions and TURN OFF POWER TO THE ELECTRICAL BOX.
PAGE 2
Assemble the Fixture 1D 2A 3 1 CABLE CLUTCH POWER CORD 4 AIRCRAFT CABLE 4 Line up an anchor with the center of a backplate hole and push the anchor in up to the threads. 5 Screw the anchor the rest of the way in with a screwdriver. 1E 7 NOTE: Make sure to support the fixture while adjusting the aircraft cables. An assistant is recommended to complete the remaining steps. 6 6 Secure the backplate to the anchor with a screw and washer. 7 Repeat steps 4-6 for the remaining anchor hole.
PAGE 3
Adjust the Power Cord 3A DRIVER WIRE 3C POWER CORD WIRE 6 5 1 Take note of the wire connections and remove the wire nuts to disconnect the power cord wires from the driver wires. 5 From the end of the cord, strip the insulation 4" using a sharp knife. Make sure not to nick the inner wires. 6 Cut off the extra cord, strip 1/2" off the wire ends, and reconnect the power cord wires to their original connections (reversal of 3A).
PAGE 4
B SCREW SCREW 4 Place all wires and wire nut connections inside the canopy. 5 Align the canopy holes with the crossbar holes. Secure the canopy in place by tightening the four screws. SAVE THESE INSTRUCTIONS! 4C 6 CABLE CLUTCH BAND CABLE CLUTCH BAND 6 If necessary, adjust the aircraft cables until the fixture is level; feed the cable into the cable clutch to raise the fixture and push in on the cable clutch nipple to release the cable and lower the fixture.