Installation Sheet

STEM
FIXTURE
1
2A
Determine desired length of fixture using the provided
stems and assemble them by screwing them together.
Feed the fixture wires through the stem assemblies and
screw them to the fixture.
3
Assemble the Fixture
2
2
1
1
4
2
2B
Feed the fixture wires through the canopy and place the
canopy onto the stem assemblies.
Secure the canopy to the stems by installing the flat
washers, lock washers, and nuts (in that order) onto the
stems, then secure them in place by screwing the nuts
onto the stems. Slide the sleeves over the wires and into
the stems.
FLAT WASHER
FIXTURE WIRES
STEM
NUT
LOCK WASHER
SLEEVE
Leave 12" of the cord behind the canopy for power
connections. Cut the excess cord.
Strip the end of the wires.
1
2
3A
12"
Install the Fixture
MOUNTING
PLATE
ELECTRICAL BOX
3B
5
7
6
3
Connect the ground wire to a suitable ground in
accordance with local electrical codes.
Connect the black wires to the neutral power wire with
a wire nut.
Connect the red wires to the hot power wire with a wire
nut.
Neatly place all wires and wire nut connections in the
canopy and reinstall the canopy to the mounting plate
(reversal of step 1A).
4
5
6
7400 Linder Ave, Skokie, 60077IL
847.410.4400
www.techlighting.com
© 2018 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!