Installation Sheet

Installation Instructions for

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing

NEC compliant junction boxes.

This product is suitable for damp locations.

Incandescent version may be dimmed with a standard incandescent

dimmer. LED version may be dimmed with a LED dimmer. Consult

lamp manufacturer for additional information.

Line Wave 2 Linear

Install the Mounting Plate

CANOPY

Separate the mounting plate from the canopy by

unscrewing the four mounting plate screws on the

canopy using the provided Allen wrench.

MOUNTING

PLATE SCREW

Remove the mounting plate from the canopy.

MOUNTING PLATE

CANOPY

Secure the mounting plate to the electrical box with the

two #8-32 screws provided.

MOUNTING

PLATE

#8-32 SCREW

ALLEN WRENCH

CHANDELIER

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

920LSLWAVE2

1.2

700LSLNV_

PAGE 1
Installation Instructions for 920LSLWAVE2 Line Wave 2 Linear 700LSLNV_ 1.2 CHANDELIER GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. Incandescent version may be dimmed with a standard incandescent dimmer. LED version may be dimmed with a LED dimmer. Consult lamp manufacturer for additional information.
PAGE 2
Assemble the Fixture Install the Fixture 2A 3A 12" 1 1 Leave 12" of the cord behind the canopy for power connections. Cut the excess cord. 2 Strip the end of the wires. STEM 3B 1 ELECTRICAL BOX 5 6 FIXTURE MOUNTING PLATE 7 2 1 Determine desired length of fixture using the provided stems and assemble them by screwing them together. 3 Connect the ground wire to a suitable ground in accordance with local electrical codes.