Installation Guide

AIRCRAFT
CABLE
CABLE
CLUTCH
19
1I
19
Adjust the aircraft cables until the fixture is level; feed
the cable into the cable clutch to raise the fixture and
push in on the cable clutch nipple to release the cable
and lower the fixture.
Cut off the excess aircraft cable.
Ensure that the set screws in both the canopy and the
cable post are tight with the provided Allen wrench.
Move on to section 3 for lamp and shade installation.
17
18
19
20
17
17
ALLEN WRENCH
#6-32
SET SCREW
Ensure that the set screws in both the canopy and the
cable post are tight with the provided Allen wrench.
1J
21
21
3
Two Cable Post Configuration
Mark the anchor point locations 28.5” apart and in
accordance to the canopy position.
1
28.5”
2A
ANCHOR
CEILING
Tap one of the anchors at the marked point into the wall
up to the threaded portion with a hammer.
2B
2
2
FRONT SURFACE
OF THE ANCHOR
Screw the anchor in the rest of the way with a Phillips
screwdriver.
The arrows on the front surface of the anchor indicate
what direction the toggle will open. Adjust the position
of the anchor by slightly turning it clockwise.
3
4
4
4
2C
3