Installation Guide

#8 SCREW
THREADED WASHER
6
2E
Screw the threaded washer onto the anchor with the
long #8 screw.
6
2D
THREADED
WASHER
CABLE POST
Unscrew the threaded washer to separate it from the
cable post.
5
THREADED WASHER
2F
CABLE POST
Tightly screw the cable post back onto the threaded
washer.
7
4
AIRCRAFT
CABLE
CABLE
CLUTCH
2G
Adjust the aircraft cables until the fixture is at the
desired height and level; feed the cable into the cable
clutch to raise the fixture and push in on the cable
clutch nipple to release the cable and lower the fixture.
Cut off the excess aircraft cable.
8
9
8
8
ALLEN WRENCH
#6-32
SET SCREW
Ensure that the set screws in both the canopy and the
cable post are tight with the provided Allen wrench.
2H
10
10