Installation Guide

Loosen the screw and cap on the canopy.
Pull the power cord through the canopy until it reaches
the length and look desired.
Leave 6 inches of cord behind the canopy and cut off
extra cord.
11
2I
CORD
CAP
SCREW
13
12
11
11
13
NOTE: The power cord does not support the fixture.
For a casual “lazy cord” look, cut the power cord
several inches longer than the drop height of the
fixture.
Strip the cable behind the canopy, and strip the ends of
the inner wires.
Tighten the screw and cap on the canopy.
14
2J
CAP
14
15
15
15
5
16
2K
17
18
Connect the bare wire to a suitable ground in
accordance with local electrical codes.
Connect the wire with the white strip to the neutral
power line wire with a wire nut.
Connect the remaining wire to the hot power line wire
with a wire nut.
2L
Place all wires properly into the electrical box.
Mount the canopy to the electrical box with two #8-32
screws provided.
19
20
2020
5
6
7