Installation Sheet
2
Remove the Allen screws on the sides of the canopy using the provided Allen wrench, then remove the mounting plate
from the canopy.
Temporarily install the mounting plate onto the electrical box with the two #8-32 screws provided.
Mark the location of the drywall anchors. Then remove the mounting plate.
Tap the drywall anchors into the drywall at the marked locations.
Reinstall the mounting plate and screw the anchor screws into place using the provided screws and washers.
Assemble the stems to the desired height and feed the fixture wires through the stem assemblies. CAUTION: Do not over-
tighten the stems, as it may cause the stems to misalign.
Screw the stem assemblies to the fixture.
Loosen the hex nuts on the pivots, then screw the stems to the pivots. If mounting to an angled ceiling, adjust both pivots
so that they face the same direction in order to hang the fixture straight. Note: pivots accommodate up to a 45 degree
ceiling. Re-tighten the hex nuts and tighten the set screws on the pivots to secure in place.
Connect the fixture to suitable ground in accordance with local electrical codes.
Connect the white fixture wires to the neutral power line wire with a wire nut.
Connect the black fixture wires to the hot power line wire with a wire nut.
Properly place all wires and wire nut connections into the canopy, mount the fixture back onto the mounting plate, and
reinstall Allen screws (reversal of step 1).
Install the lamp according to fixture model. carefully insert the lamp pins into the holes on the socket.For Bi-Pin lamps,
For E12 lamps, screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
Install the glass shades by carefully screwing them onto the threads on the sockets. Make sure the glass shade is
installed correctly before releasing. Do not over-tighten.
1
1A
2
3
4
5
6
7
8
9
10
11
1
1
2
2
4
4
8
5
5
FIXTURE
DRYWALL
ANCHOR
SCREW
DRYWALL
ANCHOR
MOUNTING
PLATE
ALLEN
SCREW
STEM ASSEMBLY
CANOPY
12
SOCKET
LAMP
GLASS SHADE
13
14
13
14
6
6
7
CAUTION: To reduce the risk of a burn or electric shock during re-lamping, disconnect the power to the fixture.
10
11
9
ALLEN
WRENCH
HEX NUT
PIVOT
8