Installation Sheet

2
CIRCULAR
PLYWOOD
MONORAIL
Start bending the rest of the MonoRail against the
circular plywood until the desired curve or circle is
achieved.
HOOK
ARM
PEDAL
MONORAIL
Wiremold Pipe Bender (Horizontal
and Vertical Bend)
Feed the MonoRail through the pipe bender hook. Start
bending the MonoRail by gently pulling back on the arm
of the pipe bender.
Start with small angle (MAX 10°) to avoid errors in
shaping the MonoRail. After each bend unhook and
check the MonoRail against the pattern.
NOTE: The Wiremold pipe bender can be used to
create smooth horizontal curve of 90° or less. Avoid
stepping on the pedal of the pipe bender which will
flatten and damage the MonoRail.
1/16 ALLEN
WRENCH
#6-32
SET SCREW
CONDUCTIVE OR ISOLATING
JOIN CONNECTORS
ONE MONORAIL
SECTION
OTHER MONORAIL
SECTION
Freestyle Bending (Horizontal Bend
Only)
CENTER OF
BENDING SECTION
PUSH
PUSH
Choose the center of bending section on the MonoRail.
The bending point should be centered between the
hands.
To ensure a smooth curve, begin with hands as far as
apart as possible, moving the hands closer together as
bending progresses. Bend the MonoRail until the desired
shape is achieved.
Connecting the MonoRail Sections
Push two MonoRail sections completely onto the
conductive or isolating join connectors.
Tighten the #6-32 set screws with the 1/16 Allen
wrench provided. Make sure that the set screw
connection for conductive connector is tight to avoid
heat build up and corrosion. For the isolating connector,
tighten the #6-32 set screw firmly to avoid stripping the
thread.
SAVE THESE INSTRUCTIONS!
2B
5
5
3A
1
2
1
4A
1
2
1
2 2
5A
1
2
1 1
2
7400 Linder Ave, Skokie, IL 60077
847.410.4400
www.techlighting.com
© 2008 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company