Installation Sheet

ManualsBrandsTech Lighting ManualsPendantsTech Lighting Blok Single Light 22-1/2" High MonoRail LED Pendant with a Hexagonal Metal Shade

1.0

Installation Instructions for

Blok Pendant

700FJBLK_

920FJBLOK

P-LVENDANTS OW OLTAGE

GP I :ENERAL RODUCT NFORMATION

This product is listed and suitable only for indoor dryETL

locations and approved for use at any height above the

finished floor.

This product is patented (U.S. . 6,183,297).PAT

Adjust The Fixture Height

SET SCREW

Back out (do not remove) the set screw on tip of the

connector with the provided Allen wrench.

ALLEN WRENCH

SET SCREW

Back out (do not remove) the set screw on the conical

connector with the provided Allen wrench.

Pull the coaxial cable out.

ALLEN WRENCH

Tap the conical connector on a hard surface with the set

screw facing down, so the plate inside drops into place.

PLATE

SURFACE

Cut the coaxial cable to the desired length.

Gently twist the end of the coaxial cable between thumb

and forefinger.

Summary of content (4 pages)

PAGE 1
920FJBLOK Installation Instructions for Blok Pendant 700FJBLK_ 1.0 P ENDANTS -L OW V OLTAGE GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. This product is patented (U.S. PAT. 6,183,297). Adjust The Fixture Height 1A 1C ALLEN WRENCH SET SCREW 5 1 1 Back out (do not remove) the set screw on tip of the connector with the provided Allen wrench.
PAGE 2
1H 1E 11 7 CONICAL CONNECTOR OUTER WRAPPED WIRE STOPS HERE 7 11 Firmly tighten the set screw on the conical connector. Feed and push the coaxial cable into the conical connector. The coaxial cable will come to a stop point after being inserted 3/4" into the conical connector. 1F 1I WRINKLE ON OUTER WRAPPED WIRE 8 12 INNER WIRE STOPS HERE 8 Keep pushing the coaxial cable into the connector while rotating the connector to ease feeding the inner wire into the tip of the connector.
PAGE 3
Replacing the Lamp 2C C AUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. 2A METAL SHADE 5 4 3 1 1 SOCKET MR16 LAMP For incandescent versions, use MAX 50 Watt Mr16 Front Cover Halogen lamp. DIFFUSER For LED versions, use provided MAX 8 Watt LED MR16 Bi-Pin Lamp. Remove the diffuser by supporting the metal shade and pulling down on the diffuser to separate it from the metal shade. 2B 3 Remove the old lamp.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2017 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.