Installation Guide

Installation Instructions for

Elton

700FJELT_

920FJELTO

HEADS-LOW VOLTAGE

SOCKET PIN

LAMP PIN

LOUVER OR

(OPTIONAL NOT INCLUDED)

GLASS LENS

MR16 LAMP

CAP

Unscrew and remove the cap from the louver holder.

Push the MR16 lamp pins all the way into the socket

pins.

Place the Louver (optional, not included) or the glass

lens (optional, not included) in front of the lamp, into

the louver holder.

Screw the cap onto the louver holder.

LOUVER

HOLDER

CAUTION: To reduce the risk of a burn or electric

shock during relamping, disconnect the power to the

fixture.

Use MAX 35 Watt, MR16 Front Cover

Halogen Lamp For Each Head.

1.6

GENERAL PRODUCT INFORMATION:

This product is ETL listed and suitable only for indoor dry

locations and approved for use at any height above the

finished floor.

PAGE 1
920FJELTO Installation Instructions for Elton 700FJELT_ 1.6 HEADS-LOW VOLTAGE GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. 1A LOUVER HOLDER SOCKET PIN LAMP PIN 4 MR16 LAMP LOUVER OR GLASS LENS (OPTIONAL NOT INCLUDED) 2 3 1 CAP CAUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture.
PAGE 2
IMPORTANT SAFETY INSTRUCTIONS Halogen Lamp General Information To reduce the risk of fire, electrical shock, exposure to excessive UV radiation, or injury to person: – A new halogen lamp may smoke slightly when it is used for the first time. This is perfectly normal; the protective coating is simply being vaporized. – Use this fixture indoors only. Two Tips For Prolonging Halogen Lamp Life – Do not look directly at the lighted lamp. – Do not remain in light if skin feels warm.