Installation Sheet

1
NOTE: When extending the MonoRail power feed
canopy, refer to the instruction provided with the power
feed extenders before following the steps below.
Install the Power Feed Canopy
1A
#8-32 SCREW
NOTE: Use the provided universal round crossbar when the
canopy holes do not line up with the electrical box holes.
1
2
POWER LINE WIRES
Disconnect power to the electrical box.
Connect the white transformer wire to the neutral
power line wire with a wire nut.
Connect the black transformer wire to the hot power
line wire with a wire nut.
Connect the fixture to a suitable ground in accordance
with local electrical codes.
Connect the canopy wires to the transformer output
wires with wire nuts.
Place the transformer, wires, and wire nut connections
inside the electrical box.
Mount power feed canopy to the electrical box with the
two #8-32 screws.
TRANSFORMER
3
4
6
7
5
1.2
Installation Instructions for
Single Feed Electronic LED Transformer Canopy
700MOFRT60_-LED
920MOPCLED
SURFACE TRANSFORMERS
7
5 5
3
2
6
7
GP I :ENERAL RODUCT NFORMATION
This fixture is intended to be installed utilizing
NEC compliant junction boxes with a minimum
depth of 2”.
Minimum volume of the junction box must be 6 cubic inches
(98 cubic centimeter).
This product may be dimmed with a low-voltage electronic
dimmer.
This product is suitable for indoor dry locations only.