Installation Sheet

P-LVENDANTS OW OLTAGE

GP I :ENERAL RODUCT NFORMATION

This product is listed and suitable only for indoor dryETL

locations and approved for use at any height above the

finished floor.

1.0

Installation Instructions for

Mezz Pendant

700FJMEZ

920FJMEZZP

Adjust The Fixture Height

SET SCREW

Back out (do not remove) the set screw on tip of the

connector with the provided Allen wrench.

ALLEN WRENCH

SET SCREW

Back out (do not remove) the set screw on the conical

connector with the provided Allen wrench.

Pull the coaxial cable out.

ALLEN WRENCH

Cut the coaxial cable to the desired length.

Gently twist the end of the coaxial cable between thumb

and forefinger.

SURFACE

PLATE

Tap the conical connector on a hard surface with the set

screw facing down, so the plate inside drops into place.

CONICAL CONNECTOR

OUTER WRAPPED

WIRE STOPS HERE

Feed and push the coaxial cable into the conical

connector. The coaxial cable will come to a stop point

after being inserted 3/4" into the conical connector.

PAGE 1
920FJMEZZP Installation Instructions for Mezz Pendant 700FJMEZ 1.0 P ENDANTS -L OW V OLTAGE GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. Adjust The Fixture Height 1C 1A ALLEN WRENCH 5 SET SCREW 1 1 Back out (do not remove) the set screw on tip of the connector with the provided Allen wrench. 4 Cut the coaxial cable to the desired length.
PAGE 2
Assemble the Fixture 2A WRINKLE ON OUTER WRAPPED WIRE 1F 8 INNER WIRE STOPS HERE 8 COAXIAL CABLE Keep pushing the coaxial cable into the connector while rotating the connector to ease feeding the inner wire into the tip of the connector. The outer wrapped wire will start wrinkling while being inserted another 1/2" into the connector.