Installation Sheet

2
WRINKLE ON OUTER
WRAPPED WIRE
1F
INNER WIRE STOPS HERE
8
Keep pushing the coaxial cable into the connector while
rotating the connector to ease feeding the inner wire
into the tip of the connector. The outer wrapped wire
will start wrinkling while being inserted another 1/2" into
the connector.
8
Look into the sight hole on the top of the connector to
make sure that the inner wire is contacting the end of
the connector.
Hold the coaxial cable in place and tighten the set screw
on tip of the connector with the provided Allen wrench.
Make sure this set screw connection is tight.
SIGHT HOLE
INNER WIRE
ALLEN WRENCH
9
10
9
10
1G
Firmly tighten the set screw on the conical connector.
1H
11
11
Pull the coaxial cable toward the fixture to smooth the
wrinkles.
1I
12
12
Assemble the Fixture
Feed the coaxial cable through the shade and carefully
lower the shade onto the stopper.
2A
1
COAXIAL CABLE
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, 60077IL
847.410.4400
www.techlighting.com
© 2018 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company
STOPPER
LED ASSEMBLY
SHADE