Installation Sheet
2
Install the Rectangular Power Feed
Canopy
Connect the power feed canopy wires to the low
voltage wires coming from the remote transformer in
the electrical box with wire nuts.
Mount the rectangular power feed canopy to the
electrical box with the two #6-32 screws.
WALL
RECTANGULAR
CANOPY
#6-32
SCREWS
LOW VOLTAGE
TRANSFORMER WIRES
Connecting the MonoRail to the
Power Feed Canopy
Unscrew the housing nipple from the housing.
Loosen the #6-32 set screw on the housing nipple with
1/16 Allen wrench.
Place the MonoRail into the housing. Screw the housing
nipple to the housing tight by twisting the housing
nipple clockwise.
Tighten the #6-32 set screw with the 1/16 Allen wrench.
1/16 ALLEN
WRENCH
#6-32 SET SCREW
MONORAIL
HOUSING NIPPLE
HOUSING
Tighten the 3/8-24 set screw on the bottom of the
housing with the 3/16 Allen wrench.
3/8-24 SET SCREW
3/16 ALLEN
WRENCH
SAVE THESE INSTRUCTIONS!
3A
1
2
1
2
4A
1
2
3
4
3
2
4
4B
5
5
7400 Linder Ave, Skokie, IL 60077
847.410.4400
www.techlighting.com
© 2016 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company
1