Installation Guide

1.6

Installation Instructions for

MonoRail Pivot

700MOPIV_

920MOPVOT

HEADS-LOW VOLTAGE

Installing the Lamp

LAMP PIN

SOCKET PIN

MR16 LAMP

CAUTION: To reduce the risk of a burn or electric

shock during relamping, disconnect the power to

the fixture.

For MR16 pivot, use MAX 75 Watt, Front

Cover Halogen

Gently push the lamp pins all the way into the socket

pins.

NOTE: Use only your fingers and a soft cloth to

replace the lamp.

For MR11 pivot, use MAX 35 Watt, Front

Cover Halogen

GENERAL PRODUCT INFORMATION:

This product is ETL listed and suitable only for indoor dry

locations and approved for use at any height above the

finished floor.

This product should be used with Tech Lighting MonoRail

system only.

Wild Thing, Sun Louver Lens Holder, Flight Paper, MR16

Snout, Round Glass Shield, Cone Glass Shield, Lil Egypt, Lil

Wok, Barndoors, Snap Barndoors, Backlight Shield, Louver

Lens Holder, Snap Louver Lens Holder, Eggcrate Louver, &

Glass Lens are the compatible accessories.

PAGE 1
Installation Instructions for 920MOPVOT MonoRail Pivot 700MOPIV_ HEADS-LOW VOLTAGE GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. This product should be used with Tech Lighting MonoRail system only.
PAGE 2
Installing the Fixture IMPORTANT SAFETY INSTRUCTIONS 2A To reduce the risk of fire, electrical shock, exposure to excessive UV radiation, or injury to person: OPEN PART OF THE FIXTURE SPRING – Use this fixture indoors only. – Do not look directly at the lighted lamp. 1 – Do not remain in light if skin feels warm. – Risk of fire: Use only the type of lamp and maximum wattage indicated in this instruction manual.