Installation Sheet

1.0

Installation Instructions for

Mini-Ponte Pendant

700FJPNT

920FJMPONTE

GP I :ENERAL RODUCT NFORMATION

This product is listed and suitable only for indoor dryETL

locations and approved for use at any height above the

finished floor.

Adjust The Fixture Height

SET SCREW

Back out (do not remove) the set screw on tip of the

connector with the provided Allen wrench.

ALLEN WRENCH

SET SCREW

Back out (do not remove) the set screw on the conical

connector with the provided Allen wrench.

Pull the coaxial cable out.

ALLEN WRENCH

P-LVENDANTS OW OLTAGE

Assemble the Pendant

Feed the fixture cord through the ring and carefully

lower the ring onto the LED assembly.

FIXTURE CORD

LED ASSEMBLY

RING

PAGE 1
920FJMPONTE Installation Instructions for Mini-Ponte Pendant 700FJPNT 1.0 P ENDANTS -L OW V OLTAGE GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. Assemble the Pendant Adjust The Fixture Height 1A 2A 1 ALLEN WRENCH SET SCREW RING 1 FIXTURE CORD 1 Back out (do not remove) the set screw on tip of the connector with the provided Allen wrench.
PAGE 2
C 2G ALLEN WRENCH INNER WIRE 5 10 9 4 Cut the coaxial cable to the desired length. 5 Gently twist the end of the coaxial cable between thumb and forefinger. SIGHT HOLE 2D 9 Look into the sight hole on the top of the connector to make sure that the inner wire is contacting the end of the connector. 10 Hold the coaxial cable in place and tighten the set screw on tip of the connector with the provided Allen wrench. Make sure this set screw connection is tight.