Installation Sheet

1.7
Installation Instructions for
Rigid Standoff
700MOS_
1
920MOSRGD
GENERAL PRODUCT INFORMATION:
This product is suitable for indoor dry locations only.
This product must be used with Tech Lighting MonoRail
system only.
Use the MonoRail rigid standoff every three feet and over
the MonoRail join connectors.
STANDOFFS
ANCHOR
CEILING
Select a location on the ceiling where the MonoRail is to
be mounted.
One way of marking the standoff locations on the
ceiling is to lay the MonoRail on the floor underneath of
the selected location and by using a plumb bob pointing
on the center of the MonoRail mark the points on the
ceiling.
The other way is to hold the MonoRail directly against
the ceiling and mark the standoff points on the ceiling.
Tap the anchors at the marked points up to the threaded
portion with a hammer.
Screw the anchors in the rest of the way with a Phillips
screwdriver.
ANCHOR
CEILING
THREADED
WASHER
#8 SCREW
ANCHOR
Attach the threaded washer to the anchor with the #8
screw.
1
2
3
4
1A
4
1B
5
1C
5
6
6