Installation Guide

1.6

Installation Instructions for

Sprocket

700FJSP_

920FJSPRK

HEADS-LOW VOLTAGE

Line the lamp pins up with the socket and insert the

lamp pins all the way into the socket holes.

Hook one end of the Sprocket lamp holder spring (the

small one) on front of the MR16 lamp. Wrap the spring

through the slot in the middle of the Sprocket and hook

the other end onto the front of the MR16 lamp.

MR16 LAMP

SLOT IN THE

MIDDLE OF THE

SPROCKET

LAMP HOLDER

SPRING

Lamp Installation Without an

Accessory

CAUTION: To reduce the risk of a burn or electric

shock during relamping, disconnect the power to

the fixture.

Use MAX 75 Watt, MR16 Front Cover Halogen

Lamp.

GENERAL PRODUCT INFORMATION:

This product is ETL listed and suitable only for indoor dry

locations and approved for use at any height above the

finished floor.

Wild Thing, Sun Louver Lens Holder, Flight Paper, MR16

Snout, Barndoors, Snap Barndoors, Backlight Shield, Louver

Lens Holder, Eggcrate Louver, Glass Lens, Shy, Spy, Jazz

Handle, and Steel Wheel are the compatible accessories.

PAGE 1
920FJSPRK Installation Instructions for Sprocket 700FJSP_ 1.6 HEADS-LOW VOLTAGE GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. Wild Thing, Sun Louver Lens Holder, Flight Paper, MR16 Snout, Barndoors, Snap Barndoors, Backlight Shield, Louver Lens Holder, Eggcrate Louver, Glass Lens, Shy, Spy, Jazz Handle, and Steel Wheel are the compatible accessories.
PAGE 2
Lamp Installation With Typical Backlight Shield & Louver Holder Accessory IMPORTANT SAFETY INSTRUCTIONS 2A – Use this fixture indoors only. To reduce the risk of fire, electrical shock, exposure to excessive UV radiation, or injury to person: EGG CRATE LOUVER OR GLASS LENS (OPTIONAL -NOT INCLUDED) – Do not look directly at the lighted lamp. LOUVER BASE (OPTIONAL - NOT INCLUDED) – Do not remain in light if skin feels warm.