Installation Guide

2
SAVE THESE INSTRUCTIONS!
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to person:
– Use this fixture indoors only.
– Do not look directly at the lighted lamp.
– Do not remain in light if skin feels warm.
– Risk of fire: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
– Never cover the halogen lamp with anything other than a
Tech Lighting lamp shield and never place flammable
material close to your fixture.
– Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
– Do not touch the fixture shades or lamp shield while the
fixture is on. These surfaces may be HOT.
Halogen Lamp General Information
– A new halogen lamp may smoke slightly when it is used for
the first time. This is perfectly normal; the protective
coating is simply being vaporized.
Two Tips For Prolonging Halogen
Lamp Life
– First avoid touching the lamp with bare hands during
installation. Any contaminant, even the oil from your
hands can deteriorate the lamp. Rubbing alcohol can be
used to remove any contaminant.
– Second, do not run the lamps at full power when you do
not need to. However, if dimming the fixture for an
extended period of time, occasionally bring the light up to
full brightness for a few minutes to complete the halogen
cycle.
2A
Lamp Installation With Typical
Backlight Shield & Louver Holder
Accessory
EGG CRATE LOUVER OR GLASS LENS
(OPTIONAL -NOT INCLUDED)
BACKLIGHT SHIELD
(OPTIONAL -
NOT INCLUDED)
LOUVER HOLDER CAP
(OPTIONAL - NOT INCLUDED)
LOUVER BASE
(OPTIONAL - NOT INCLUDED)
MR16 LAMP
2B
Push the louver base (optional-not included) into the
backlight shield (optional-not included).
Insert the MR16 lamp into the louver base with the
backlight shield.
Place the louver (optional-not included) into the louver
cap (optional-not included).
Screw the louver cap onto the louver base.
Line the lamp pins up with the socket pins and insert the
lamp pins all the way into the socket holes.
Hook one end of the Sprocket louver holder spring
(large one) onto the front of the louver holder. Wrap the
spring over the slot in the middle of the Sprocket and
hook the other end on front of the louver holder.
SLOT IN THE
MIDDLE OF THE
SPROCKET
LAMP HOLDER
SPRING
BACKLIGHT
SHIELD
LOUVER
LENS
HOLDER
1
2
3
4
1 2
3 4
5
6
5
6
6
7400 Linder Ave, Skokie, IL 60077
847.410.4400
www.techlighting.com
© 2008 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company