Installation Sheet

ManualsBrandsTech Lighting ManualsLightingMonoRail Surface Transformer-60W El LED

1.0

Installation Instructions for

Single Feed Surface Electronic Transformer

700MOSRT60E_/100E_-LED

920MOSFESF

SURFACE TRANSFORMERS

CAUTION—RISK OF FIRE

This product requires installation by a qualified

electrician. Before installing be sure to read all

instructions and DISCONNECT POWER TO THE

ELECTRICAL BOX.

On the side of the transformer dome cover, remove the

#4-40 screws with a Phillips head screwdriver.

Lift the dome cover off of the transformer housing.

Install the Transformer

Connect the ground wire to a suitable ground in

accordance with local electrical codes.

Connect the black transformer wire to the hot power line

wire with a wire nut.

Connect the white transformer wire to the neutral power

line wire with a wire nut.

ELECTRICAL BOX

GENERAL PRODUCT INFORMATION:

This product is ETL listed and suitable only for indoor dry

locations and approved for use at any height above the

finished floor.

A typical installation is shown. Specific installation must be

in accordance with local electrical codes.

This product is dimmable with a low-voltage electronic

dimmer.

This product is intended for use with Tech Lighting low

voltage lighting systems only.

Read all instructions thoroughly. Read "Important Safety

Information" on page 3 before proceeding with the

installation.

Summary of content (4 pages)

PAGE 1
920MOSFESF Installation Instructions for Single Feed Surface Electronic Transformer 700MOSRT60E_/100E_-LED 1.0 SURFACE TRANSFORMERS GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. A typical installation is shown. Specific installation must be in accordance with local electrical codes. This product is dimmable with a low-voltage electronic dimmer.
PAGE 2
1D 1C 8 7 8 7 #4-40 SCREW COVER 6 Place all power line wires and wire nut connections properly into the electrical box. 7 Mount backplate to the electrical box with the provided two #8-32 round head screws. 8 2 Line up the cover holes with the backplate holes. Replace and tighten the two #4-40 screws.
PAGE 3
Connect the Transformer to the MonoRail Important Safety Information Do not conceal or extend bus bar conductors through a building wall. 2A To reduce the risk of fire and burns, do not install this lighting system where the uninsulated open bus bar conductors can be shorted or contact any conductive materials. To reduce the risk of the system overheating and possibly causing a fire, make sure all the connections are tight.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2008 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.