Installation Sheet

Important Safety Information

Do not conceal or extend bus bar conductors through a

building wall.

To reduce the risk of fire and burns, do not install this

lighting system where the uninsulated open bus bar

conductors can be shorted or contact any conductive

materials.

To reduce the risk of the system overheating and possibly

causing a fire, make sure all the connections are tight.

Do not install fixture assemblies closer than six inches to

curtains or similarly combustible materials.

Turn the electrical power off before modifying the lighting

system in any way.

The fixtures used with the system must be identified to be

used with the corresponding system.

Minimum volume of the electrical box must be 6 cubic

inches (98 cubic centimeter).

Load the circuit of the remote transformers to no more than

the maximum rated capacity as specified.

To reset the electronic surface transformer, turn the power

off then on (main power, breaker panel, or wall switch).

Connect the Transformer to the

MonoRail

Unscrew the housing from the housing nipple.

Loosen the #6-32 set screw on the housing nipple with

the 1/16 Allen wrench.

Place the MonoRail into the housing. Screw the housing

nipple to the housing tight by twisting the housing

nipple clockwise.

Tighten the #6-32 set screw on the housing nipple with

the 1/16 Allen wrench.

Tighten the 3/8-24 set screw on the bottom of the

housing with the 3/16 Allen wrench.

SECTION OF

MONORAIL

HOUSING

NIPPLE

1/16 ALLEN

WRENCH

3/16 ALLEN WRENCH

3/8-24

SET SCREW

#6-32 SET SCREW