Installation Guide

Table Of Contents
1.6
Installation Instructions for
Tilt
700FJTLT_
1
920FJTILT
HEADS-LOW VOLTAGE
NEEDLENOSE PLIERS
If the accessory shade fits tight or loose onto the Tilt
fixture, then carefully bend the grooved shade holder
tabs in or out slightly with needlenose pliers.
GROOVED SHADE
HOLDER TAB
CAUTION: To reduce the risk of a burn or electric
shock during relamping, disconnect the power to
the fixture.
NOTE: Use only your fingers and a soft cloth to
replace the lamp.
NOTE: Bend the grooved shade holder tabs carefully.
Excessive bending may break the tabs.
Use MAX 50 Watt, MR16 Front Cover Halogen
Lamp.
ACCESSORY SHADE
MR16 LAMP
Insert the MR16 lamp into the proper accessory shade.
Line up the lamp pins with the socket holes. Insert the
MR16 lamp pins into the socket holes, simultaneously
push the accessory shade onto the grooved shade
holder.
LAMP PINS
SOCKET HOLES
1A
1B
1C
1
2
3
1
2
3
GENERAL PRODUCT INFORMATION:
This product is ETL listed and suitable only for indoor dry
locations and approved for use at any height above the
finished floor.
Round, Cone, Martini, Dichroic, Firebird or Prism Glass
Shield, Belladonna, Bell, Tinkerbell, Lil Egypt, Meteorite,
Moonlet or Droplet are the compatible accessories.

Summary of content (2 pages)