Installation Sheet

1.0

Installation Instructions for

Akova Pendant

700FJAKV_

920FJAKOVA

P-LVENDANTS OW OLTAGE

GP I :ENERAL RODUCT NFORMATION

This product is listed and suitable only for indoor dryETL

locations and approved for use at any height above the

finished floor.

Adjust The Fixture Height

SET SCREW

Back out (do not remove) the set screw on tip of the

connector with the provided Allen wrench.

ALLEN WRENCH

SET SCREW

Back out (do not remove) the set screw on the conical

connector with the provided Allen wrench.

Pull the coaxial cable out.

ALLEN WRENCH

Cut the coaxial cable to the desired length.

Gently twist the end of the coaxial cable between thumb

and forefinger.

SURFACE

PLATE

Tap the conical connector on a hard surface with the set

screw facing down, so the plate inside drops into place.

PAGE 1
920FJAKOVA Installation Instructions for Akova Pendant 700FJAKV_ 1.0 P ENDANTS -L OW V OLTAGE GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. Adjust The Fixture Height 1C 1A ALLEN WRENCH SET SCREW 5 1 1 Back out (do not remove) the set screw on tip of the connector with the provided Allen wrench. 4 Cut the coaxial cable to the desired length.
PAGE 2
1H 1E 7 11 CONICAL CONNECTOR OUTER WRAPPED WIRE STOPS HERE 7 Feed and push the coaxial cable into the conical connector. The coaxial cable will come to a stop point after being inserted 3/4" into the conical connector. 11 Firmly tighten the set screw on the conical connector. WRINKLE ON OUTER WRAPPED WIRE 1F 1I 12 8 12 Pull the coaxial cable toward the fixture to smooth the wrinkles.