Canopy Installation Sheet

2.6
Installation Instructions for
4" FreeJack Canopy
700 4 _, 700 4 _FJ SQ FJ RF
1
920 4FJ RCN
GP I :ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
This fixture is intended to be used utilizing NEC compliant
junction boxes with enough room to house the transformer.
Halogen ballast dimensions: 2.66”L x 1.30”H x 0.83”D
LED driver dimensions: 2.76”L x 1.62”H x 0.91”D
Model numbers ending in “- or “- 277” can beLED LED
dimmed with a low-voltage electronic dimmer, have a rated
maximum output of 60 watts, and are compatible with LED
elements.
A
ll other model numbers can be dimmed with a standard
incandescent dimmer, have a rated maximum output of 75
watts, and are not compatible with elements.LED
For wood canopies: Do not install any head or pendant
closer than 12 inches to this canopy. Heat from the lamp
may damage the wood finish.
SINGLE P CANOPIESORT
Ground the canopy in accordance with local electrical
code.
Connect the white transformer wire to the neutral
power line wire with a wire nut.
Connect the black transformer wire to the hot power
line wire with a wire nut.
Place the transformer and all the wires inside the
electrical box. Use the adhesive pad to secure the
transformer in the electrical box.
Mount the canopy crossbar to the electrical box with the
two long #8-32 screws.
POWER LINE WIRES
TRANSFORMER
WIRES
#8-32 SCREW
CANOPY
CROSSBAR
CEILING
ELECTRICAL BOX
1
2
3
4
5
1A
1
2
3
5 5
1
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.

Summary of content (2 pages)