Installation Sheet

Installing the Lamps & Shades
CAUTION: To reduce the risk of a burn or electric
shock during relamping, disconnect the power to
the fixture.
Push the lamp pins all the way into the socket.
Unscrew to remove the washers from the sockets.
SOCKET
Place a socket into a glass shade.
Slide the glass shade up to expose the socket.
Replace and tighten the washer to the socket.
GLASS
SHADE
4
WASHER
LAMP
SOCKET
Carefully slide the glass shade down so that it rests on
top of the washer.
Repeat steps 2 through 6 for the remaining six glass
shades.
To replace a lamp, slide the glass shade up, remove the
old lamp, and repeat steps 5 and 6.
WASHER
GLASS SHADE
WASHER
SOCKET
3
NOTE: If using Cheers accessory (optional-not
included), refer to the instruction provided with the
accessory.
2A
1
1
2B
2
3
4
2
3
4
2C
5
6
7
8
2D
6
5
NOTE: Use only your fingers and a soft cloth to
install or replace the lamp.
Use MAX 10 Watt Xenon (Xelogen) bi-pin
lamp.
For LED versions, use provided MAX 8 Watt LED
Bi-Pin Lamp.