Installation Sheet

ManualsBrandsTech Lighting ManualsPendantsTech Lighting Diz 1 Light Monopoint 12v Bowl Shaped Pendant with 4" Round Canopy and Clear Glass Shade

1.1

Installation Instructions for

Diz

700FJDIZ_

920FJDIZP

PENDANTS-LOW VOLTAGE

Adjust The Fixture Height

#6-32 SET SCREW

Back out (do not remove) the #6-32 set screw on tip of

the connector with the provided 1/16 Allen wrench.

1/16 ALLEN WRENCH

#6-32 OVAL HEAD

SET SCREW

Back out (do not remove) the #6-32 oval head set screw

on the conical connector with the provided 1/16 Allen

wrench.

Pull the coaxial cable out.

1/16 ALLEN WRENCH

Cut the coaxial cable to the desired length.

Gently twist the end of the coaxial cable between thumb

and forefinger.

Feed and push the coaxial cable into the conical

connector. The coaxial cable will come to a stop point

after being inserted 3/4" into the conical connector.

CONICAL CONNECTOR

OUTER WRAPPED

WIRE STOPS HERE

GENERAL PRODUCT INFORMATION:

This product is ETL listed and suitable only for dry locations

and approved for use at any height above the finished floor.

This product is patented (U.S. PAT. 6,183,297).

Summary of content (4 pages)

PAGE 1
920FJDIZP Installation Instructions for Diz 700FJDIZ_ 1.1 PENDANTS-LOW VOLTAGE GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for dry locations and approved for use at any height above the finished floor. This product is patented (U.S. PAT. 6,183,297). Adjust The Fixture Height 1A 1C 1/16 ALLEN WRENCH #6-32 SET SCREW 5 1 1 Back out (do not remove) the #6-32 set screw on tip of the connector with the provided 1/16 Allen wrench.
PAGE 2
1G 1E WRINKLE ON OUTER WRAPPED WIRE 10 7 INNER WIRE STOPS HERE 7 Keep pushing the coaxial cable into the connector while rotating the connector to ease feeding the inner wire into the tip of the connector. The outer wrapped wire will start wrinkling while being inserted another ½" into the connector. 10 Tighten the #6-32 oval head set screw on the conical connector firmly. 1H 1F 1/16 ALLEN WRENCH 11 INNER WIRE 9 8 11 Pull the coaxial cable toward the fixture to smooth the wrinkles.
PAGE 3
Replacing the Lamp 2B C AUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. NOTE: Use only your fingers and a soft cloth to replace the lamp. ALLEN WRENCH 3 2A MR16 LAMP GLASS DISC SET SCREW Use MAX 50 Watt type MR16 Front Cover Halogen Lamp. ALLEN WRENCH 1 2 MR16 LAMP 3 GLASS DISK 1 Hold the glass disk and lamp with one hand and loosen (Do Not Remove) the bottom two set screws with the provided Allen wrench.
PAGE 4
IMPORTANT SAFETY INSTRUCTIONS Halogen Lamp General Information To reduce the risk of fire, electrical shock, exposure to excessive UV radiation, or injury to person: – It is normal for a new halogen lamp to smoke slightly on first use. The protective coating is being vaporized. – Use this fixture indoors only. – Do not look directly at the lighted lamp. Prolonging Halogen Lamp Life – Do not remain in light if skin feels warm. – Do not touch the lamp with bare hands.