Installation Sheet

ManualsBrandsTech Lighting ManualsPendantsTech Lighting Mini Echo 1 Light Monopoint Halogen 12v Mini Pendant with 4" Round Canopy and Smoke Glass

2.0

Installation Instructions for

Mini Echo

700 _FJECP

920FJECHO

P-LVENDANTS OW OLTAGE

GP I :ENERAL RODUCT NFORMATION

This product is listed and suitable only for indoor dryETL

locations and approved for use at any height above the

finished floor.

Adjust The Fixture Height

SET SCREW

Back out (do not remove) the set screw on tip of the

connector with the provided Allen wrench.

ALLEN WRENCH

SET SCREW

Back out (do not remove) the set screw on the conical

connector with the provided Allen wrench.

Pull the coaxial cable out.

ALLEN WRENCH

Cut the coaxial cable to the desired length.

Gently twist the end of the coaxial cable between thumb

and forefinger.

Tap the conical connector on a hard surface with the set

screw facing down, so the plate inside drops into place.

PLATE

SURFACE

Summary of content (4 pages)

PAGE 1
Installation Instructions for 920FJECHO Mini Echo 700FJECP_ 2.0 P ENDANTS -L OW V OLTAGE GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. Adjust The Fixture Height 1A 1C ALLEN WRENCH SET SCREW 5 1 1 Back out (do not remove) the set screw on tip of the connector with the provided Allen wrench. 4 Cut the coaxial cable to the desired length.
PAGE 2
1H 1E 11 7 CONICAL CONNECTOR OUTER WRAPPED WIRE STOPS HERE 7 11 Firmly tighten the set screw on the conical connector. Feed and push the coaxial cable into the conical connector. The coaxial cable will come to a stop point after being inserted 3/4" into the conical connector. 1F 1I WRINKLE ON OUTER WRAPPED WIRE 8 12 INNER WIRE STOPS HERE 8 Keep pushing the coaxial cable into the connector while rotating the connector to ease feeding the inner wire into the tip of the connector.
PAGE 3
Installing the Outer Glass & Lamp 2A 2C NYLON WASHER STUD 1 1 THUMB SCREW INNER GLASS OUTER GLASS BI-PIN LAMP 3 LAMP SHIELD Line up the outer glass holes with the inner glass studs and secure the outer glass to inner glass with provided thumb screws and nylon washers. 1 3 Remove the lamp shield and the old lamp. 2D 2B GLASS SHADE 2 SOCKET 4 For incandescent versions, use MAX 50 Watt Bi-Pin Halogen Lamp.
PAGE 4
2E GLASS SHADE 7 SOCKET 6 6 Push the lamp shield onto the spring clip. 7 Gently lower the shades onto the socket assembly. SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2016 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.