Installation Sheet

SET SCREW

Back out (do not remove) the set screw on tip of the

connector with the provided Allen wrench.

ALLEN WRENCH

SET SCREW

Back out (do not remove) the set screw on the conical

connector with the provided Allen wrench.

Pull the coaxial cable out.

ALLEN WRENCH

Fold and hold the arms, insert the LED assembly into the

shade, center the LED assembly to the shade and release

the arms. Adjust as necessary.

LED ASSEMBLY

SHADE

ARM

Installation Instructions for

920FJMPALONA

Mini-Palona Pendant

GP I :ENERAL RODUCT NFORMATION

This product is ETL listed and suitable only for indoor

dry locations and approved for use at any height above

the finished floor.

PENDANTS

1.0

SAVE THESE INSTRUCTIONS!

700FJPLN

1.1

PAGE 1
Installation Instructions for 920FJMPALONA Mini-Palona Pendant 700FJPLN 1.0 1.1 PENDANTS GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. SAVE THESE INSTRUCTIONS! 2A 1A ALLEN WRENCH SET SCREW 1 LED ASSEMBLY ARM 1 SHADE Back out (do not remove) the set screw on tip of the connector with the provided Allen wrench.
PAGE 2
1C 2G ALLEN WRENCH INNER WIRE 5 10 9 SIGHT HOLE 4 Cut the coaxial cable to the desired length. 5 Gently twist the end of the coaxial cable between thumb and forefinger. 2D 9 Look into the sight hole on the top of the connector to make sure that the inner wire is contacting the end of the connector. 10 Hold the coaxial cable in place and tighten the set screw on tip of the connector with the provided Allen wrench. Make sure this set screw connection is tight.