Installation Sheet

1.0

Installation Instructions for

Mini-Powell Pendant

700FJPSP

920FJMPOWELL

GP I :ENERAL RODUCT NFORMATION

This product is listed and suitable only for indoor dryETL

locations and approved for use at any height above the

finished floor.

Adjust The Fixture Height

SET SCREW

Back out (do not remove) the set screw on tip of the

connector with the provided Allen wrench.

ALLEN WRENCH

SET SCREW

Back out (do not remove) the set screw on the conical

connector with the provided Allen wrench.

Pull the coaxial cable out.

ALLEN WRENCH

Assemble the Fixture

Feed the cord through the shade and carefully lower

the shade until it rests properly on the LED assembly.

P-LVENDANTS OW OLTAGE

LED ASSEMBLY

CORD

PAGE 1
920FJMPOWELL Installation Instructions for Mini-Powell Pendant 700FJPSP 1.0 P ENDANTS -L OW V OLTAGE GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. Assemble the Fixture Adjust The Fixture Height 1A 2A CORD ALLEN WRENCH SET SCREW 1 1 Back out (do not remove) the set screw on tip of the connector with the provided Allen wrench.
PAGE 2
C 2G ALLEN WRENCH INNER WIRE 5 10 9 4 Cut the coaxial cable to the desired length. 5 Gently twist the end of the coaxial cable between thumb and forefinger. SIGHT HOLE 2D 9 Look into the sight hole on the top of the connector to make sure that the inner wire is contacting the end of the connector. 10 Hold the coaxial cable in place and tighten the set screw on tip of the connector with the provided Allen wrench. Make sure this set screw connection is tight.