Installation Sheet

Firmly tighten the set screw on the conical connector.
2
Keep pushing the coaxial cable into the connector while
rotating the connector to ease feeding the inner wire
into the tip of the connector. The outer wrapped wire
will start wrinkling while being inserted another 1/2" into
the connector.
WRINKLE ON OUTER
WRAPPED WIRE
INNER WIRE STOPS HERE
Look into the sight hole on the top of the connector to
make sure that the inner wire is contacting the end of
the connector.
Hold the coaxial cable in place and tighten the set screw
on tip of the connector with the provided Allen wrench.
Make sure this set screw connection is tight.
SIGHT HOLE
INNER WIRE
ALLEN WRENCH
2F
8
9
10
8
9
10
2H
11
2G
Feed and push the coaxial cable into the conical
connector. The coaxial cable will come to a stop point
after being inserted 3/4" into the conical connector.
CONICAL CONNECTOR
OUTER WRAPPED
WIRE STOPS HERE
2E
7
7
11
Tap the conical connector on a hard surface with the set
screw facing down, so the plate inside drops into place.
2D
6
6
PLATE
SURFACE
Cut the coaxial cable to the desired length.
Gently twist the end of the coaxial cable between thumb
and forefinger.
2C
4
5
5
2I
Pull the coaxial cable toward the fixture to smooth the
wrinkles.
12
12
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, 60077IL
847.410.4400
www.techlighting.com
© 2020 Tech Lighting, L.L.C. All rights reserved.
Visual Comfort Group