Installation Sheet

ManualsBrandsTech Lighting ManualsLightingRevel 1 Light Monopoint Pendant with Cylinder Metal Shade with White Glass Diffuser

1.1

Installation Instructions for

Revel Pendant

700_RVL_

920FJREVEL

P-LVENDANTS OW OLTAGE

GP I :ENERAL RODUCT NFORMATION

This product is ETL listed and suitable only for indoor dry

locations and approved for use at any height above the

finished floor.

This product is patented (U.S. PAT. 6,183,297).

Adjust The Fixture Height

SET SCREW

Back out (do not remove) the set screw on tip of the

connector with the provided Allen wrench.

ALLEN WRENCH

SET SCREW

Back out (do not remove) the set screw on the conical

connector with the provided Allen wrench.

Pull the coaxial cable out.

ALLEN WRENCH

Place the outer metal shade over the inner glass shade

until it rests on top of it.GENTLY

Assemble the Fixture

OUTER METAL SHADE

INNER GLASS SHADE

Cut the coaxial cable to the desired length.

Gently twist the end of the coaxial cable between thumb

and forefinger.

Summary of content (4 pages)

PAGE 1
920FJREVEL Installation Instructions for 700_RVL_ Revel Pendant 1.1 P ENDANTS -L OW V OLTAGE GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. This product is patented (U.S. PAT. 6,183,297). Assemble the Fixture 1A 2B ALLEN WRENCH OUTER METAL SHADE SET SCREW 2 3 INNER GLASS SHADE 2 Back out (do not remove) the set screw on the conical connector with the provided Allen wrench.
PAGE 2
D 2G ALLEN WRENCH INNER WIRE SURFACE 10 PLATE 6 9 SIGHT HOLE 6 Tap the conical connector on a hard surface with the set screw facing down, so the plate inside drops into place. 9 Look into the sight hole on the top of the connector to make sure that the inner wire is contacting the end of the connector. 10 Hold the coaxial cable in place and tighten the set screw on tip of the connector with the provided Allen wrench. Make sure this set screw connection is tight.
PAGE 3
Replacing the Lamp 3B C AUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. 3A 4 BI-PIN LAMP 1 For incandescent versions, use MAX 50 Watt Bi-Pin Halogen Lamp. BI-PIN LAMP 2 For LED versions, use provided MAX 8 Watt LED Bi-Pin Lamp. LAMP SHIELD 1 Lift both the outer shade and inner glass shade up to expose the socket. 2 Remove the lamp shield and the old lamp.
PAGE 4
IMPORTANT SAFETY INSTRUCTIONS Halogen Lamp General Information To reduce the risk of fire, electrical shock, exposure to excessive UV radiation, or injury to person: – It is normal for a new halogen lamp to smoke slightly on first use. The protective coating is being vaporized. – Use this fixture indoors only. – Do not look directly at the lighted lamp. Prolonging Halogen Lamp Life – Do not remain in light if skin feels warm. – Do not touch the lamp with bare hands.