Installation Sheet

ManualsBrandsTech Lighting ManualsPendantsTech Lighting Sedona Single Light 6" Wide Monopoint Pendant with a Smooth Transparent Glass Shade

1.0

Installation Instructions for

Sedona

700 SDN_FJ

920FJSEDONA

P-LVENDANTS OW OLTAGE

GP I :ENERAL RODUCT NFORMATION

This product is listed and suitable only for indoor dryETL

locations and approved for use at any height above the

finished floor.

Adjust The Fixture Height

SET SCREW

Back out (do not remove) the set screw on tip of the

connector with the provided Allen wrench.

ALLEN WRENCH

SET SCREW

Back out (do not remove) the set screw on the conical

connector with the provided Allen wrench.

Pull the coaxial cable out.

ALLEN WRENCH

Assemble the Pendant

Feed the fixture cord through the inner shade then

gently rest the inner shade on the strain relief.

Feed the fixture cord through the outer shade and cap,

then gently rest the outer shade on the inner shade

assembly.

FIXTURE CORD

OUTER

SHADE

INNER

SHADE

ASSMEBLY

CAP

NOTE: Due to the organic nature of the glass,

position the glass for the best aesthetic appearance.

STRAIN

RELIEF

Summary of content (4 pages)

PAGE 1
920FJSEDONA Installation Instructions for Sedona 700FJSDN_ 1.0 P ENDANTS -L OW V OLTAGE GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. NOTE: Due to the organic nature of the glass, position the glass for the best aesthetic appearance.
PAGE 2
WRINKLE ON OUTER WRAPPED WIRE 2F 2C 8 5 INNER WIRE STOPS HERE 8 4 Cut the coaxial cable to the desired length. 5 Gently twist the end of the coaxial cable between thumb and forefinger. Keep pushing the coaxial cable into the connector while rotating the connector to ease feeding the inner wire into the tip of the connector. The outer wrapped wire will start wrinkling while being inserted another 1/2" into the connector.
PAGE 3
C Replacing the Lamp C AUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. NOTE: lamp shield is for halogen lamping option only. 3A GLASS ASSEMBLIES LAMP SHIELD 4 BI-PIN LAMP 2 LAMP SHIELD 5 1 Lift inner and outer glass assemblies to expose socket 2 Remove the lamp shield and the old lamp. Push the lamp shield onto the spring clip.
PAGE 4
IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of fire, electrical shock, exposure to excessive UV radiation, or injury to person: – Use this fixture indoors only. – Do not look directly at the lighted lamp. – Do not remain in light if skin feels warm. – Risk of fire: Use only the type of lamp and maximum wattage indicated in this instruction manual. – Never cover the halogen lamp with anything other than a Tech Lighting lamp shield and never place flammable material close to your fixture.