Installation Sheet

1.0

Installation Instructions for

Tellium

700FJTLM_

920FJTELLM

HEADS-LOW VOLTAGE

CAUTION: To reduce the risk of a burn or electric

shock during accessory installation, disconnect the

power to the fixture.

Unscrew the lens ring.

Push the lamp pins completely into the socket.

Place the optional lens accessory inside the

lens ring.

Screw the lens ring back on.

OPTIONAL:

LENS RING

GENERAL PRODUCT INFORMATION:

This product is ETL listed and suitable only for indoor dry

locations and approved for use at any height above the

finished floor.

(OPTIONAL) LENS ACCESSORY

LAMP

SOCKET

Use 50 Watt MR16 Front Cover Halogen

Lamp.

MAX

PAGE 1
920FJTELLM Installation Instructions for Tellium 700FJTLM_ HEADS-LOW VOLTAGE GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. C AUTION: To reduce the risk of a burn or electric shock during accessory installation, disconnect the power to the fixture. Use MAX 50 Watt MR16 Front Cover Halogen Lamp. 1A LENS RING LAMP (OPTIONAL) LENS ACCESSORY 1 Unscrew the lens ring.
PAGE 2
IMPORTANT SAFETY INSTRUCTIONS Halogen Lamp General Information To reduce the risk of fire, electrical shock, exposure to excessive UV radiation, or injury to person: – A new halogen lamp may smoke slightly when it is used for the first time. This is perfectly normal; the protective coating is simply being vaporized. – Use this fixture indoors only. Two Tips For Prolonging Halogen Lamp Life – Do not look directly at the lighted lamp. – Do not remain in light if skin feels warm.