Installation Sheet

Connect the black/blue driver wire to the black/blue fixture wire with a wire nut.
Connect the red driver wire to the red fixture wire with a wire nut.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white driver wire to the neutral power line with a wire nut.
Connect the black driver wire to the hot power line with a wire nut.
Neatly place the all wires and wire nut connections inside the canopy, place the canopy onto the mounting plate, and secure in
place by screwing the collar nut onto the screw collar.
Carefully slide the top cover, plate, and gasket up to access center of fixture, then install the fins by inserting them into the fixture
slots and securing in place using the clips.
Carefully slide the plate and gasket down, then secure the plate to the top of the fixture using the three Allen screws using the
provided Allen wrench. Slide the cover back down.
11
12
13
17
1C
DRIVER
SCREW COLLAR
18
16
17
18
14
15
11
12
15
14
COLLAR NUT
CANOPY
16
CLIP
FIN
SLOT
17
18
PLATE SCREW
COVER
PLATE
GASKET
ALLEN WRENCH
& SCREW
4