Installation Sheet

With the provided Allen wrench, loosen the set screw from the bottom of the fixture base.

Remove the mounting plate from the fixture base.

Install the mounting plate to the junction box with the two screws provided and ensure the mounting plate is level. (Use #8-32 screws

for standard 4” octagonal J-box. Use #6-32 screws for 2x4 J-box.)

Connect the red driver output wire to the red fixture wire.

Connect the black driver output wire to the black fixture wire.

Connect the fixture to a suitable ground in accordance with local electrical codes.

For 120v fixtures only: Connect the white wire to the neutral power line with a wire nut.

For 120v fixtures only: Connect the black wire to the hot power line with a wire nut.

For 12v fixtures only: Connect the black driver wires to the black junction box wires (from the remote transformer) with wire nuts.

Properly place all wires, driver and wire nut connections into the junction box, mount the fixture base onto the mounting plate, and

secure it in place by tightening the set screw using the provided Allen wrench.

(Optional):To adjust the CCT, access the CCT toggle on the bottom of the fixture by removing the two screws with the provided screw

driver. Then select the desired color temperature. Then reinstall the cover panel and secure with the two screws. It is recommended to do

this before applying sealant.

For wet locations, caulk around the base of the fixture with waterproof construction sealant.

Install the Fixture

ALLEN WRENCH

& SET SCREW

FIXTURE BASE

JUNCTION BOX

DRIVER

SCREWS

COVER

PANEL

CCT

TOGGLE

MOUNTING PLATE

WIRING DIAGRAM

FOR 120V

JUNCTION BOX

WIRING DIAGRAM

FOR 12V

TO FIXTURE