Installation Sheet

1.0

Installation Instructions for

Blade 18 & 24 Outdoor Wall

700OWBLD18, 700OWBLD24

920OWBLADE

OUTDOOR

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

GP I :ENERAL RODUCT NFORMATION

This product is suitable for wet locations.

These fixtures are intended to be installed

utilizing NEC compliant junction boxes.

This product can be dimmed with most ELV, TRIAC or 0-10V

dimmers.

This instruction shows a typical installation.

SAVE THESE INSTRUCTIONS!

7400 Linder Ave, Skokie, 60077IL

847.410.4400

www.techlighting.com

Visual Comfort Group

PAGE 1
920OWBLADE Installation Instructions for Blade 18 & 24 Outdoor Wall 700OWBLD18, 700OWBLD24 1.0 CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. OUTDOOR GENERAL PRODUCT INFORMATION: Use minimum 90°c supply conductors. This product is suitable for wet locations. These fixtures are intended to be installed utilizing NEC compliant junction boxes.
PAGE 2
Install the Fixture 1A JUNCTION BOX 3 #8-32 SCREW ALLEN WRENCH & SET SCREW 5 6 MOUNTING PLATE 7 SEALING CAP CCT TOGGLE 10 BOTTOM VIEW 1 With the provided Allen wrench, remove the set screws both sides of the fixture base. 2 Remove the mounting plate from the fixture base 3 Install the mounting plate to the junction box with the two #8-32 screws provided. 4 Connect the fixture to a suitable ground in accordance with local electrical codes.